Complete Reinitialisation Of The Telephone; Caller Id/Clip - Topcom Butler 1250 Mode D'emploi

Butler 1250
• Press the Programming key
• 'PIN' appears on the display.
• Enter your PIN code.
• Press the Programming key

4.30 Complete Reinitialisation of the telephone

This function allows you to completely reinitialise the telephone without requiring your PIN
code. This will delete all Phonebook memory entries, all handsets will be removed, all default
settings will be restored and the default PIN code will be restored to '0000'.
Do the following:
• Disconnect the battery in the telephone.
• Keep the '*' key pressed and reconnect the battery until the handset rings continually and
the display lights up. Release the '*' button and press the Programming key
• The handset finds the base unit and a signal sounds.
• Briefly press the '*' key.
• 'RESET ?' appears on the display.
• Press the Programming key
discontinue the procedure.
• 'RESETTING' appears on the display and a long beep tone sounds.
• 'NOT SUB' appears on the display. The handset is completely reinitialised.
Afterwards, you must resubscribe all handsets as described in point 4.23! However you no
longer need to set the base unit to subscription mode, because this now happens automatically!

5 CALLER ID/CLIP

(This service only works when you have a Caller ID/Clip subscription. Contact your telephone
company).
When you receive a call, the telephone number of the caller, the date and time appears on the
handset display. If the name is programmed in the Phonebook, the name in the Phonebook is
displayed!
The telephone can store 30 calls in a Call List that can be reviewed later. The telephone never
stores the same call twice. When the memory is full, the new calls automatically replace the
oldest calls in the memory. The symbol
answered. If the Call List is empty and you press the Up key
You can view the information of an incoming call as follows:
• Press the Up key . The name (if sent by the network or present in the Phonebook memory)
of the caller, the sequence number of the call in the Call List, the date and time of the call
appear on the display.
• Press the Down key
.
.
to confirm your selection of disconnect the battery to
on the display blinks if the call is not read or n o t
. The telephone number of the caller appears on the display.
96
.
, three beep tones will sound.