Control Test - E-FLITE Blade mCX2 BNF Manuel D'utilisation

Control Test

Although each Blade mCX2 model is test flown at the factory, you should test the controls prior to the
first flight to ensure none of the servos, linkages or parts were damaged during shipping and handling.
Turn the transmitter on first and lower the throttle stick completely. Then, plug the battery into the
battery lead of the 5-in-1 unit.
The connectors on the battery and battery lead are keyed to prevent reverse polarity connection. How-
ever, if you force them together in the wrong orientation/wrong polarity it is possible to damage the
battery and/or 5-in-1 unit. To help further prevent a reverse polarity connection, one side of the endcap
on the battery and the connector on the battery lead of the 5-in-1 unit have a red dot. The connectors
are oriented for a proper polarity connection when the red dots are on the same side (usually toward
the top of the helicopter).
Mode 1
Mode 2
Position the helicopter to view it from behind. Move the elevator stick on the transmitter forward and
aft to check elevator pitch control. When the stick is pushed forward, the right-hand servo should pull
the swashplate downward.
M2
M1
EN
10