Date And Time Setting; Parameter Change Prevention; Flash Memory Module Functions - WEG CFW-11 Guide Rapide D'installation

3) Basic Application Parameter Settings
After running the Oriented Start-up routine and properly setting the parameters, the inverter is ready to operate in V/f mode.
The group Basic Application has the more common application parameters.

DATE AND TIME SETTING

Access the group HMI and change: day (P0194), month (P0195) and year (P0196); time: hour (P0197), minutes (P0198) and seconds (P0199).

PARAMETER CHANGE PREVENTION

To prevent unauthorized or unintended parameter modifications, the parameter P0000 can be set to a value different from 5.

FLASH MEMORY MODULE FUNCTIONS

ƒ
Store a copy of the inverter parameters.
ƒ
Transfer parameters stored in the FLASH memory to the inverter.
ƒ
Transfer firmware stored in the FLASH memory to the inverter.
ƒ
Store the program created with SoftPLC.
Whenever the inverter is powered up, this program (SoftPLC) is transferred to the RAM memory located in the inverter control board and
executed.
Refer to the CFW-11 programming manual and to SoftPLC manual for further details.
Installation Guide
CFW-11 | 19