Date And Time Setting; Parameter Change Prevention; Flash Memory Module Functions - WEG CFW-11 Guide Rapide D'installation

Masquer les pouces Voir aussi pour CFW-11:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 85
Installation Guide
2) Oriented Start-Up
There is a group of parameters named "Oriented Start-up", which
makes the inverter settings easier. The parameter P0317 from this
group allows entering the Oriented Start-up routine.
The Oriented Start-Up routine presents the main parameters on the
HMI in a logical sequence. The minimum necessary parameters for
proper operation are adjusted. Information like mains voltage and
motor nameplate data is entered.
In order to enter into the Oriented Start-up routine, first change
parameter P0317 to 1 and then, set all remaining parameters as they
are presented on the display.
Setting the parameters in the Oriented Start-up routine causes
the automatic content modification of the other parameters and/or
internal inverter variables.
During the Oriented Start-up routine, the message "Config" will be
displayed at the top left corner of the HMI display.
3) Basic Application Parameter Settings
After running the Oriented Start-up routine and properly setting the
parameters, the inverter is ready to operate in V/f mode.
The group Basic Application has the more common application
parameters.

DATE AND TIME SETTING

Access the group HMI and change: day (P0194), month (P0195)
and year (P0196); time: hour (P0197), minutes (P0198) and seconds
(P0199).

PARAMETER CHANGE PREVENTION

To prevent unauthorized or unintended parameter modifications, the
parameter P0000 can be set to a value different from 5.

FLASH MEMORY MODULE FUNCTIONS

ƒ
Store a copy of the inverter parameters.
ƒ
Transfer parameters stored in the FLASH memory to the inverter.
ƒ
Transfer firmware stored in the FLASH memory to the inverter.
ƒ
Store the program created with SoftPLC.
Whenever the inverter is powered up, this program (SoftPLC) is
transferred to the RAM memory located in the inverter control board
and executed.
Refer to the CFW-11 programming manual and to SoftPLC manual
for further details.
18 | CFW-11

Publicité

Table des Matières
loading

Table des Matières