Gaggenau DF250 Notice D'utilisation page 40

en-us
Troubleshooting
Fault
Silverware not dry.
Appliance interior wet after rinse
cycle.
Food soils on the dishes.
Dishwasher seems to run a long
time
40
Cause
Silverware not arranged properly in
the silverware basket.
Silverware not arranged properly in
the third rack.
No appliance fault.
Dishes placed too closely together,
racks overfilled.
Spray arm rotation obstructed.
Spray arm nozzles are blocked.
Filters 1Z dirty.
Filters 1Z inserted incorrectly and/
or not engaged.
Rinse wash cycle too weak.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Tall narrow containers in corner areas
are not rinsed adequately.
Upper rack 12 on right and left not
set to same height.
Incoming water is not warm enough.
Cycle time can vary due to soil and
water conditions.
Rinse aid dispenser 9" is empty.
Dishwasher connected to cold water
supply.
Note:Check the typical wash cycle
length.
Remedial action
Separate silverware if possible, prevent
contact points.
Arrange silverware properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Arrange dishes with adequate clearance
between them ensuring that the spray jets
can reach the surface of the dishes. Prevent
contact points.
Arrange dishes so that the spray arm can
rotate without obstruction.
Clean the spray arm nozzles.
Clean filters.
Insert and engage filters correctly.
Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Do not prerinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or
Intensive.
Do not place hollow containers too
obliquely and do not place in the corner
area.
Set upper rack to same height using side
levers.
Before starting a cycle, run hot water faucet
at the sink closest to the dishwasher.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good
wash when heavy soil is detected.
Add rinse aid.
Verify dishwasher is connected to hot water
supply plumbing.