Rinse Aid; Adding Rinse Aid; Setting The Amount Of Rinse Aid Used - Gaggenau DF250 Notice D'utilisation

Rinse Aid

,
A s soon as the low rinse aid indicator H lights up on
R i n s e A i d
the control panel, rinse aid should be topped off.
The rinse aid is required for stain-free utensils and clear
glasses. Use only rinse aid which the manufacturer
designates as safe to use in domestic dishwashers.
Combined detergents with rinse aid component may be
used with soft to moderately hard water only (0-2 bands
on test strip or up to an °E value of 20). For moderately
hard to hard water (3 to 4 bands on test strip or °E value
of 21 or higher), rinse aid must be used.

Adding rinse aid

NOTICE: To avoid oversudsing or clogging, do not
overfill the rinse aid dispenser 9". Wipe up any spills
with a damp cloth.
Open the rinse aid dispenser 9" by pressing on the
1.
latch of the lid and pulling it open.
2. Add liquid rinse aid to the dispenser 9" until it is
full. Do not overfill. Avoid spilling into air vent hole.
3.
Close the lid. Lid must be fully closed until it clicks in
order to seal.
4.
Wipe up any excess rinse aid that may have puddled
when the dispenser reservoir is full.
This prevents excessive frothing during the next wash
cycle. The indicator light will go out a few moments
after the dishwasher door is shut.
Tip: For easier pouring, remove lid from the rinse aid
bottle.
NOTICE: Do not fill the rinse aid dispenser 9" with
detergent. Doing so will damage the dishwasher.

Setting the amount of rinse aid used

The amount of rinse aid to be dispensed can be set from
0 to 6. Set the amount of rinse aid to be dispensed to 5
to obtain a very good drying result. Do not change the
amount of rinse aid unless there are streaks or water
stains on the utensils. Set a lower level to avoid streaks.
Set a higher level to avoid water stains.
Set the amount of rinse aid as follows:
1.
Open the door.
Press on ON/OFF button (.
2.
Press Info button ( 8 for 3 seconds until the
3.
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with t 3 sec.
Keep pressing button > )* until the rinse aid
4.
dispenser is indicated on the display window at the
top @.
5. Make the selection with setting buttons + - X.
6. Press and hold the Info button (8 for 3 seconds.
The chosen setting has now been stored.
Note: Do not change the amount of rinse aid unless
there are streaks (select lower setting) or water stains
(select higher setting) visible on the utensils.
en-us
Rinse Aid
17