Changing Start Wash Cycle; Tone Volume; Button Volume; Child-Proof Lock - Gaggenau DF250 Notice D'utilisation

en-us
Operating the Dishwasher

Changing start wash cycle

You can change the "Start wash cycle" setting.

Tone volume

The end of the wash cycle is indicated by a buzzer. You
can also change this setting.

Button volume

When you are operating the dishwasher, a signal
sounds whenever a button is pressed. You can control
the volume of the signal. If you do not like the button
volume, you can switch it off.

Child-proof lock *

T he dishwasher features an electronic child-proof lock.
C h i l d - p r o o f l o c k
The child-proof lock protects children from potential
hazards which the dishwasher poses.
You can switch the child-proof lock on or off. When the
child-proof lock is on, it is difficult to open the door.
* optional feature which may or may not be included with
your dishwasher.

Greeting

When you switch on the dishwasher, the brand logo
appears. You can switch off the brand logo.

Factory setting

You can reset all settings to the factory setting.
32

Switching the appliance on

1.
Turn the water supply on fully.
2.
Open the door.
3. Switch on On/Off switch (.
The AUTO 130 - 150° F wash cycle has been preset
as a default whenever the appliance starts. This wash
cycle remains selected if no other wash cycle button
0 is pressed.
Press Start button )".
4.
5.
Close the door.
Wash cycle sequence starts.
Note: Your dishwasher is protected against
unintentional operation. If the appliance door remains
open for more than 4 seconds after pressing the Start
button, the operation will be paused. Press the Start
button again and close the appliance door.

Delay start time

You can delay the start of the wash cycle by up to
24 hours. Depending on the setting of the time display,
the end of cycle is indicated with "Finish in" (for
example 3h 25m) or "Finish at" (for example 15:20
hours).
1.
Open the door.
Switch on On/Off switch (.
2.
Select wash cycle 0.
3.
4. Press Delay start button `.
5. Keep pressing the setting buttons + - X until the
displayed time corresponds with your requirements.
6. Press Start button )", timer programming is
activated.
To delete the Delay start time, press Start button )"
7.
for about 3 seconds.
8.
Close the door.
Note: Your dishwasher is protected against
unintentional operation. If the appliance door remains
open for more than 4 seconds after pressing the Start
button, the operation will be paused. Press the Start
button again and close the appliance door.