Electrical Connection; Removing The Appliance - Gaggenau DF250 Notice D'utilisation

en-us
Installation and connection

Electrical connection

Connect the appliance to an 120 V, 60 Hz alternating
▯
current only, via a correctly installed outlet with
protective grounding conductor. See rating plate for
required fusing 9:.
The outlet must be near the appliance and freely
▯
accessible after the installation.
If the plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3 mm
must be fitted on the installation side to satisfy the
relevant safety instructions.
The connection may be modified by technicians only.
▯
A power cord extension may be purchased from
▯
customer service only.
Use only a residual current operated circuit-breaker
▯
which features the symbol ‚. Only this extension
guarantees compliance with the currently valid
regulations.
The appliance features a water damage protection
▯
system. Please note the system will function only
when the power supply is connected.
50

Removing the appliance

Also observe the sequence of worksteps here.
1.
Disconnect the appliance from the power supply.
2.
Turn off the tap.
3.
Undo the drain water and water supply connection.
4.
Loosen fastening screws for the cabinet parts.
5.
If fitted, remove the base panel.
6.
Pull out the appliance, carefully pulling the hose
behind.