Installation Instruction; What To Do If; General - Atag HEK611 Notice D'utilisation

FAULTS
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first. Phone
the service department if the advice given below does not help. Only
authorised personnel may open the appliance or carry out work on
the mains power supply. Damage caused by incorrect connection,
incorrect installation or incorrect use is not covered by the warranty.
In the case of faults visit the internet site 'www.atagservice.nl'.
FAULT
Hot plates do not get hot. Plug not (or not
GB 12

What to do if...

inhoud
CAUSE SOLUTION
Put the plug into the
completely) in the socket. socket.
Fuse(s) in the meter Check the fuses in the
cupboard defective. meter cupboard.

INSTALLATION INSTRUCTION

Warning
• Panels and furniture lining of the kitchen cabinet receiving
the hob must be treated with temperature resistant adhesives
(100°C), otherwise they might be discoloured or deformed
because of inadequate temperature resistance.
• The cooking hob is intended for building into the worktop above
the kitchen element of 60 cm width or more.
• Bottom kitchen element must not be equipped with a drawer. If
the kitchen element has a built-in horizontal shelf, it must be at
a distance of not less than 15 cm from the bottom surface of the
worktop. The space between the shelf and the cooktop must be
empty and may not be used for storage of utensils.
• The use of hard wood decorative borders around the worktop
behind the appliance is allowed, in case the minimum distance
remains as indicated on the installation illustrations.
• Minimum distance between the built-in cooktop and rear wall
is indicated at the illustration for the installation of the built-in
cooktop.
• The appliance may be installed in any worktop with a thickness
from 30 mm to 50 mm.
Dimensions of the built-in hob opening
GB 13

General