Installation Instructions; Electrical Connection; Building In - Atag Cook-light Mode D'emploi

installation instructions

electrical connection

230 V - 50 Hz
Connected load: HL2..C 7257 W
HL2..L 7200 W
HL2..B 6300 W
Always comply with the locally applicable
regulations for the electrical connection.
The connection possibilities and connected
loads are indicated on the data plate at the
bottom of the appliance.
building-in
Exept in the case of the HL2..C, the appliance
has already been fitted with a connection cable
in the factory. So all you have to do is attach a
plug to this cable. The cable is heat-resistant. If
the cable is damaged, a similar cable should be
used as replacement, for example
H05VVF5 1.5 mm , with a resistance to
2
temperatures of 105 °C.
The appliance is delivered with a sealing strip.
1. Fit the plug in accordance with the
connection diagram.
2. Saw out the recess in the worktop. Do this
very accurately, bearing in mind the
building-in dimensions on the previous
page. If necessary, saw out also the
partitions.
installation instructions
(continued)
3. Remove the protective foil from the sealing
strip and attach the strip to the middle of the
edge of the hob.
4. Lower the hob into the recess.
5. Fix the hob in position with the clamps
supplied.
6. Connect the plug to the power supply.
7. Finally, check that the appliance functions
properly.