Installation Instructions; General - Atag HG62 B Serie Manuel D'utilisation

Plaque de cuisson à gaz
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS

General

EN 22
Caution!
• The fitting of the appliance should only be carried out by a certified
installer.
• The type of gas and the country for which the appliance has been
designed are indicated on the data card.
• This is a category 3 appliance.
Gas connection
• The gas connection must comply with national and local
regulations.
• We recommend that the hob be connected by means of a fixed
pipe.
• Connection using a specially designed safety hose is also
permitted.
• Behind an oven always install a full metal pipe.
Warning!
• A safety hose may not be bent and must not come into contact with
moving parts of kitchen units.
• In all cases the connection tap for the appliance must be positioned
at an is easily accessible location.
• Before using the appliance for the first time, verify that there
are no gas leaks using water and washing-up liquid at the gas
connections.
Electrical connection
230V - 50Hz - 1.1 VA (for ..B appliances)
230V - 50Hz - 5.1 VA (for ..C appliances)
• The electrical connection must comply with national and local
regulations.
• Wall socket and plug must be accessible at all times.
• If you make a permanent connection, ensure that an omnipolar
switch with a contact gap of at least 3 mm is fitted in the supply
cable.
• Do not use an adapter or an extension lead to connect the device
to the electrical mains. Safe use of the device cannot be guaranteed
with these accessories.

Publicité

Table des Matières
loading

Table des Matières