Installation - Faro edi Mode D'emploi

INSTALLATION

Mod. S/TS "edi" Dental Lamp
Make sure all the components listed below are included in the package received.
•
S/TS Dental Lamp (in the requested version)
•
Wrench for removing Front Screen
•
Instruction Manual
THIS DEVICE SHOULD BE INSTALLED BY
SPECIALIZED TECHNICIANS
POWER SHOULD ALWAYS BE CUT OFF DURING
INSTALLATION.
•
The Lamp with Transformer is to be powered directly by mains voltage
with the same characteristics shown on the data plate or in the
specifications given in the Manual.
•
Make sure the Line Switch is in conformity with the surface distances by
air as specified in IEC Publication 328
•
The lamp without transformer is to be powered with low voltage alternate
current by using a safety transformer with an outlet at 17V a.c. 6A and
with thermal protection and/or secondary circuit shielded with a proper
fuse (T6.3A)
18