Machine Operation (Scrubbing/Drying); Machine Transport/Parking - Clarke Vantage 17 Cable Manuel D'utilisation

EN
ENGLISH

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine according to the procedure shown in
the previous paragraph.
2. While keeping both hands on the handlebar (I, Fig. 10),
move the machine and start scrubbing/drying the floor.
CAUTION:
To avoid damaging the floor surface:
– Do not use the brush/pad without the solution.
– When the machine is stopped, stop the
brush/pad by releasing the switches (A, Fig. 10).
CAUTION:
Before lifting the brush/pad, stop its rotation by
releasing the switches (A, Fig. 10).
3. If necessary, adjust the solution flow sent to the
brush/pad by turning the lever (B, Fig. 10).
Machine Speed Adjustment
4. The machine speed depends on the type of floor to be
cleaned and on the choice of using brush or pad.
If necessary, it is possible to adjust the machine speed by
following the relevant procedure in the Maintenance
chapter.

MACHINE TRANSPORT/PARKING

After operation, proceed as follows to transport/park the
machine.
1. Turn the brush/pad rotation switch and the water
vacuuming switch (F and G, Fig. 10) to the "0" position.
2. Disconnect the power supply cable plug (C, Fig. 10) from
the electrical mains. Roll up the power supply cable on
the handlebar into position (J).
3. Lift the squeegee by pushing the lever (H, Fig. 10)
completely upwards.
4. Grasp the handlebar (A, Fig. 11) and slightly lower it until
the rear wheel (B) comes into contact with the floor, as
shown in the figure. While holding the machine in this
position, push it to the transport/parking area.
14
Figure 10
Figure 11
Operator's Manual - Vantage 17 Cable