Machine Start And Stop - Clarke Vantage 17 Cable Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MACHINE START AND STOP

Start
1. Prepare the machine according to the procedure shown
in the previous paragraph.
2. If the machine has not yet been connected to the
electrical mains, connect it proceeding as follows.
Connect the power supply cable (I) to the extension (H,
Fig. 8) supplied. Connect the extension plug (J) to the
electrical mains.
WARNING:
Before connecting the machine to the electrical
mains, make sure that the frequency and voltage
shown in the serial number plate/technical data (M,
Fig. 8) match the mains voltage.
3. Lower the squeegee (A, Fig. 8) by pushing the lever (B)
downwards.
4. Turn the solution flow control lever (C, Fig. 8) to one of
the following positions, according to the type of cleaning
to be carried out:
– ECO system: When the lever (C, Fig. 8) is in the
"ECO" position (D), the machine works in a special
condition of programmed water "economy" usage; as
the water flow is set and constant, the machine can
work with a cleaning time of 70-80 minutes [0.08
gal/min (0.3 liters/min].
– Variable system: When the lever is turned to the left
(variable flow), it is possible to increase the capacity
up to 0.26 gal/min (1 liter/min) (E, Fig. 8).
During machine operation, it is not possible to completely
close the water flow to the brush/pad.
5. Turn the switches (F and G, Fig. 8) to the "I" position.
6. While keeping both hands on the handlebar (K, Fig. 8),
start the machine by pressing one or both the activation
switches (L).
Machine Stop
7. Release the switches (L, Fig. 8).
8. Turn the switches (F and G, Fig. 8) to the "0" position.
9. Disconnect the power supply cable plug (J) from the
electrical mains. If necessary, roll up the power supply
cable (H, Fig. 8) on the handlebar into position (N).
10. Lift the squeegee by pushing the lever (B, Fig. 8)
completely upwards.
11. Lift the brush/pad by activating (B, Fig. 9) the
transport/parking device (A) after inserting the relevant
pin (C).
Operator's Manual - Vantage 17 Cable
ENGLISH
Figure 7
Figure 8
Figure 9
EN
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vantage 17 cable 115vVantage 17 cable 230vVantage 17

Table des Matières