Recovery Tank Removal; Stored Machine - Clarke Vantage 17 Cable Manuel D'utilisation

EN
ENGLISH

RECOVERY TANK REMOVAL

To perform check and maintenance operations, it may be
necessary to remove the recovery water tank (15, Fig. H)
according to the following procedure:
1. Empty the tank (A, Fig. 15) according to the procedure
shown in the relevant paragraph.
2. Drive the machine on a level ground.
3. Make sure that the power supply cable (M, Fig. 14) is
disconnected from the electrical mains.
4. Disconnect the vacuum hose (A, Fig. 14) from the
squeegee (B).
5. Disconnect the recovery tank drain hose (C, Fig. 14) from
the bracket (D).
6. Open the cover (B, Fig. 15) and apply the cover stand
(C).
7. Grasp the recovery tank (A, Fig. 15) in the area (D) and
slightly lift it, as shown in the figure.
8. Disconnect the vacuum hose (E, Fig. 15) from the tank,
then remove the tank (A) with the hoses (F) and (G).

STORED MACHINE

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the operations described in the paragraph After
using the machine.
2. Store the machine in a clean and dry place, with the
brush/pad and the squeegee lifted or removed.
16
Figure 14
Figure 15
Operator's Manual - Vantage 17 Cable