Additional Safety Warnings; Technical Data - MIRKA LEROS Instructions D'utilisation

Masquer les pouces Voir aussi pour LEROS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en

Additional safety warnings

• Read all instructions before using this tool . All operators must be fully trained in the proper, safe use of this tool .
• Always refit the cover cap after installing the backing pad .
• All maintenance must be carried out by trained personnel . For service, contact a Mirka authorized service center!
• Always use the tools with a residual current device (RCD) with a rated residual current of 30 mA or less .
• The power supply socket and connector are non-IEC appliance couplers . Only use an original Mirka power cord . The
Mirka power cord can be bought from your Mirka Dealer .
• Check the tool, backing pad, power cord and fittings regularly for wear .
• Clean or replace the dust extractor's collection bag regularly . Dust can be highly combustible . Cleaning or replacing
the bag also assures optimum performance .
• Always ensure that the power tool specifications correspond to the power source (V, Hz) .
• Take care to prevent clothing, ties, hair, cleaning rags, etc ., from getting caught in the tool's moving parts .
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair .
Additional warnings
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm . Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemicallytreated lumber .
Your risk from these exposures varies, depending on how often you do this type of work . To reduce your exposure to
these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles .

Technical data

Mirka® LEROS
Power
Mains voltage
Speed
Orbit
Size of backing pad
Weight
Degree of protection
Noise and vibration information
Measured values are determined according to EN 62841-1 .
Mirka® LEROS
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K *
Specifications subject to change without prior notice . Model range may vary between markets .
12
Mirka® LEROS Random Orbital Sander • 225 mm (9") • 110 V
950CV
250 W
100–120 VAC
4,000–8,000 rpm
5 .0 mm (3/16")
Ø 225 mm (9")
3 .5 kg (7 .72 lbs)
I
950CV
)
84 .3 dB(A)
pA
)
95 .3 dB(A)
WA
3 .0 dB
*
< 2 .5 m/s
h
1 .5 m/s
2
2

Publicité

Table des Matières
loading

Table des Matières