Compliance Statements - MIRKA LEROS Instructions D'utilisation

Compliance statements

This device complies with part 15 of the FCC Rules . Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation .
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful interference in a
residential installation . This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications .
However, there is no guarantee that interference will not occur in a particular installation . If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna .
• Increase the separation between the equipment and receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help .
NOTE: The user is cautioned that any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment .
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s) . Operation is subject to the following two conditions:
1 . This device may not cause interference .
2 . This device must accept any interference, including interference that may cause undesired operation of the device .
WARNING
• Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool .
• The electrical safety of the tool is ensured only by using original Mirka backing pads .
• Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication .
• Read the Materials Safety Data Sheet (MSDS) for the work surface .
• Use the tool with dust extraction . A suitable dust extraction unit will reduce hazardous dust .
• Do not overreach . The operator must always stand in a secure position with a firm grip and firm footing on a solid
floor .
• Do not wear loose clothing or jewelry . Keep hair, clothing and gloves away from moving parts . Loose clothes, jewelry
or long hair can get caught in moving parts .
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention . Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations .
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust .
Power tools create sparks which may ignite the dust or fumes .
CAUTION
• Keep work area clean and well lit .
• Before changing the abrasive always disconnect the power source . Make sure the abrasive is perfectly centered and
firmly attached to the backing pad .
• Keep children and bystanders away while operating a power tool . Distractions can cause you to lose control .
• Always pay attention to work safety . Never carry, store or leave the tool unattended with the power source
connected .
• Keep hands clear of the spinning pad during use .
• Do not allow the tool to free speed without taking precautions to protect any persons or objects from the loss of the
abrasive or backing pad .
• Do not use in wet conditions .
Mirka® LEROS Random Orbital Sander • 125 mm (9") • 110 V
en
11