Bluetooth - MIRKA LEROS Instructions D'utilisation

en

Bluetooth

This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed . For more information on the App functionality and if it is available in your country,
go to www .mirka .com .
Activate Bluetooth on your Mirka® LEROS as follows:
1 . Connect the power cord to mains outlet .
2 . Press and hold the rpm+ button while switching the tool on with the On/Off button .
3 . The LED above the On/Off button lights up (blue), to indicate that Bluetooth is active .
4 . Bluetooth is deactivated when the tool is disconnected from mains outlet .
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated .
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc . and any use of
such marks by Mirka Ltd is under license . Other trademarks and trade names are those of their respective owners .
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B
and C, RSS-GEN, RSS-247 and FCC §15 .247 .
Maintenance
Always disconnect the power before carrying out maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
Tools required: Hex socket 19 mm and Torx T8 screwdriver .
1 . Remove the cover cap . Untighten the screw to remove the backing pad .
2 . Remove the screw .
3 . Remove the old pad .
4 . Attach the new backing pad to the spindle (aligned correctly) and tighten the pad screw with the hex socket .
5 . Attach the cover cap .
Replacing the backing pad and interface
Tools required: Flat head screwdriver .
Pad with grip: Change as described in section replacing backing pad .
Plain pad with interface:
1 . Remove hole screws (8 pcs) .
2 . Remove the interface .
3 . Removing and attaching backing pad . See section above "Replacing the backing pad" .
4 . Fit a new interface .
5 . Refit hole screws (8 pcs) .
Replacing the brake seal
1 . Remove the backing pad as described above .
2 . Pull the old brake seal out of its groove .
3 . Insert the new brake seal in the groove .
4 . Refit the backing pad as described above .
14
Mirka® LEROS Random Orbital Sander • 225 mm (9") • 110 V