Additional Safety Warnings - MIRKA DEOS Instructions D'utilisation

WARNING
• Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool .
• The electrical safety of the tool is ensured only by using original Mirka backing pads .
• Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication .
• Read the Materials Safety Data Sheet (MSDS) for the work surface .
• Use the tool with dust extraction . A suitable dust extraction unit will reduce hazardous dust .
• Do not overreach . The operator must always stand in a secure position with a firm grip and firm footing on a solid
floor .
• Do not wear loose clothing or jewelry . Keep hair, clothing and gloves away from moving parts . Loose clothes, jewelry
or long hair can get caught in moving parts .
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention . Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations .
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust .
Power tools create sparks, which may ignite the dust or fumes .
CAUTION
• Keep work area clean and well lit .
• Always ensure that the work piece to be sanded is firmly fixed in place .
• Before changing the abrasive always disconnect the power source . Make sure the abrasive is perfectly centered and
firmly attached to the backing pad .
• Keep children and bystanders away while operating a power tool . Distractions can cause you to lose control .
• Always pay attention to work safety . Never carry, store or leave the tool unattended with the power source
connected .
• Keep hands clear of the pad during use .

Additional safety warnings

• Read all instructions before using this tool . All operators must be fully trained in the proper, safe use of this tool .
• All maintenance must be carried out by trained personnel . For service, contact a Mirka authorized service center .
• Always use the tools with a residual current device (RCD) with a rated residual current of 30 mA or less .
• The power supply socket and connector are non-IEC appliance couplers . Only use an original Mirka power supply
cable . The Mirka power supply cable can be bought from your Mirka Dealer .
• Check the tool, backing pad, power cord and fittings regularly for wear .
• Clean or replace the dust extractor's collection bag daily . Dust can be highly combustible . Cleaning or replacing the
bag also assures optimum performance .
• Always ensure that the power tool specifications correspond to the power source (V, Hz) .
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair .
Compliance
This device complies with part 15 of the FCC Rules . Operation is subject to the following two conditions:
1 . This device may not cause harmful interference .
2 . This device must accept any interference received, including interference that may cause undesired operation .
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful interference in a
residential installation . This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications .
However, there is no guarantee that interference will not occur in a particular installation . If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Mirka® DEOS • 81 x 133 mm (3" x 5") & 70 x 198 mm (3" x 8")
en
9