Publicité
Les langues disponibles
Les langues disponibles
H
=
high power
• Every time you pull the pull-cord, you switch the patio heater to the
next setting.
• The patio heater does not have a thermostat and continues to give out
heat until it is switched off. Always keep a close eye on the patio heater
when it is switched on!
• If you wish to switch the patio heater off, you need to pull on the pull-
cord repeatedly until the setting indicator shows "0"
• Remove the plug from the socket when the patio heater is not in use.
FALL PROTECTION
The patio heater is equipped a fall safeguard. It will automatically switch
off if, despite the precautionary measures you have taken, the device falls
over.
In this event, unplug the device immediately.
Always check the patio heater carefully for damage. You can then re-hang
the heater. Never use a damaged device but take it to your dealer or a
recognised service point to be checked and/or repaired.
If you cannot find any damage, set the patio heater to the 0 setting, plug in
and operate via the pull-cord. Monitor the patio heater closely for the first
fifteen minutes; if any defects occur, unplug immediately and take it to
your dealer/service point to be repaired.
CLEANING
Always switch the patio heater off and unplug before cleaning. Clean
using a damp cloth and, if necessary, a little cleaning fluid. Never use
corrosive or abrasive cleaning agents!
After a while, dust and debris may gather behind the grille (2). The grille
can be removed by unscrewing the four small screws at the side of the
heating element and gently lifting off. Use a soft brush to carefully remove
dust and debris. Never use a compressor as this could damage the lamps
or the reflector. Replace the grille and secure.
INFORMATION ABOUT DISPOSING AND RECYCLING
THIS DEVICE
Please note that this product carries the symbol showing a crossed-
through dustbin. This means that the patio heater cannot be disposed of
10
2000 Watt
Publicité
