Modifying The Water Temperature Setting - Cola TERMO-FOCUS M Manuel D'installation, D'utilisation Et D'entretien

When the room temperature has reached the set value or the fume
temperature has reached the max. set value, the output is
automatically brought to the min. value, MODULATION status.
If the STANDBY mode is activated, the stove is shut down with a
delay time after reaching the SET temperature. Restart occurs
when the room temperature is lower than a certain fixed value with
respect to the room temperature.

4.4.2 Modifying the water temperature setting

To modify the water temperature just select the MODIFY WATER
SET mode by pressing the button P1.
Then use the buttons 'P1' and 'P2' : the display shows the current
SET temperature status.
When the water temperature has reached the set value,
as a condition also at the same time as that described in par.4.4.1,
the output is automatically brought
MODULATION status.
4.4.3 Restart from STANDBY
After shutdown, the stove goes to cooling status, bringing the fume
extractor speed to the set value for brazier cleaning. Relighting
occurs as soon as the room temperature reach the SET value.
4.4.4 Cleaning the brazier
During normal operation in work mode, the 'BRAZIER CLEANING'
mode is activated at fixed intervals for a set duration.
to the min. value,
Dialogue box
57
Clock
Room temperature
Dialogue box Set output
Water temperature set value
Dialogue box
Room temperature
Clock
Dialogue Water temperature
Set output
Clock
TERMO-FOCUS M
Water
temperature