Table Des Matières; Special Features - ANSMANN Racing xMove 2.0 Station Mode D'emploi

Intelligent Digital Balance Charger
xMove 2.0 Station
Instruction Manual
Microprocessor controlled high-performance rapid charger/
discharger/balancer for NiCd/NiMH/Lithium/Pb batteries
with cell voltage balancer.
USB PC link, temperature sensor and built-in Lithium battery
balancer charge current up to 7 A, discharge current up to
5 A, 1 to 8 series of Lilo/LiPo/LiFe, 1 to 27 cells of NiCd/
NiMH, 2 to 36 V of Lead-acid (Pb).
Content
1. Special Features ................................................2
2. Performance Parameter ......................................3
3. Exterlor and Accessories ......................................3
4. Key Fetures ......................................................3
5. Operating Instructions ........................................4
6. Warning and Error Messages .............................. 13
7. Safety Messages ............................................. 14
8. After-sale Service and Guarantee ......................... 14
You need to keep this manual in a safe place, and be sure to pass it
on to the new owner if you ever dispose of xMove 2.0 Deluxe.
2
We reserve the right to commit modifications. Copyright reserved.

1. Special Features

1.1 This charger employs an advanced charging calculation and
design which allow multilayer error to be compatible. It can
create a safe charging condition and maximum reduce of
danger, caused by negligence or setting error of the user.
1.2 This item adopt prevalent synchronous buck & boost converter
technology, this makes the conversion efficiency up to 90%.
1.3 Accept all types of RC batteries:
LiPo, Lilo, LiFe, Niffl, NiCd, Pb.
1.4 Simple and efficient user interface makes operation easy,
with powerful function and abundant information. Realtime
shows you the battery voltage, charge current, temperature of
batteries, capacity of charge/discharge, elapsed time, input
voltage etc., therefore, you can inquire the present state and
establish various safety limited parameters conveniently.
1.5 The charger employs an individual cell voltage balancer to
maintain your pack in balance while charging/discharging.
During the process, it can monitor and balance each cell of the
pack individually (Tolerance: ±0.01 V).
1.6 Accept individual battery charging/discharging, so you can
extend the scope of application of the charger that is equally
useful for the DIY battery.
1.7 Various of charging modes to meet different demand:
Charging auto/balance charging/fast charging/storage and
cyclic charging etc.
1.8 For users convenience it can store and load maximum
five data of different batteries. You can establish the data
contains program setting of the battery to charge or discharge
continually. These data can be called out at any time you need
and the process can be executed without program setting.
1.9 Perform 1 - 5 cycles of charge > discharge or discharge >
charge continually for NiMH/NiCd refreshing.
1.10 You can connect a high-precision digital temperature sensor
to protect the charger works in a safety temperature. Once
a battery reaches the maximum temperature you set during
charge/discharge, the process will be terminated to protect
the battery. This is very important for NiMH/NiCd (separately
purchased temperature sensor).
1.11 For technical experts, the charger offers a PC based program
that can analyse the characteristics of the battery by USB port.
It shows a graph of voltage, current, capacity and temperature
curves. And it also shows the individual voltage of each cell in
the Lithium battery pack. (Separately purchased program kit).
Instruction Manual