ANSMANN Racing xMove 2.0 Station Mode D'emploi page 8

Picture 1: Connection diagram for the
balance/storage/discharging mode
5.3.1 Start to charge/discharge: After setup the mode menu correctly, press
"Enter/Start" key for more than 2 seconds to start the process.
8
Picture 2: Individual cell connection
diagram
This screen shows the number of cells you set up and the processor
detects.
"R": shows the number of cells found by charger and
"S": is the number of cells selected by you at the previous menu.
lf both numbers are identical you can start charging by pressing the
"Enter/Start" button.
If not, press the "Mode/Esc" button to go back to the previous menu,
then carefully check the number of cells of the battery pack to charge
again. lf you selected the AUTO mode or discharge mode, you can
pass over this screen directly.
This screen shows the present situation during charging process. To
stop charging press the "Mode/Esc" key once. As you can see in the
sketch on left
➀ for the cells count
➁ for the operating mode,
CHG = charging at auto mode
BAL = balance charging mode
FAS = fast charging
STO = storage mode
DSC = discharge mode
➂ elapsed time
➃ charge/discharge current
➄ charge/discharge voltage of battery
➅ capacity of charge/discharge
Instruction Manual