ANSMANN Racing xMove 2.0 Station Mode D'emploi page 7

5.3 Lithium batteries (Lilo/LiPo/LiFe)
program
Intelligent Digital Balance Charger xMove 2.0 Station
Press "Mode/Esc" key to the screen on the left, then press
"Enter/Start" key to enter into the parameter setting menu. You can
switch detailed at the same level by "Dec. >/Inc. <" key. Please refer
the detailed flow chart on the left.
When you are willing to alter the parameter value in the program,
press "Enter/Start" key to make it blink. Then change the value with
"Dec. >/Inc. <" key. The value will be stored by pressing "Enter/
Start" key once. Then pres "Enter/Start" key for more than 2 seconds
to start the process.
"AUTO charging" this is for individual Lithium battery or some special
battery pack without balance port or cell count. The left side of the
first line shows the type of battery you select at the user setting. The
right side of the first line shows you the mode of charge. The value on
the left side of the second line sets a charge current and the value on
the right side of the second line sets the cells count of the battery. The
definition of the following screens are all the same. (To know how to
connect, please refer to the picture on the next page).
"Balance charging" this is for 2 – 6 cells of Lithium battery with
balance port, the battery pack being charged should have the
individual cell connect, and connect it to the individual port at the
right side of the charger with a suitable connection cable that fits with
your battery pack (see picture). In this mode, the charging process
will be different from ordinary charging mode. The internal processor
of the charger will monitor and control the voltage of each cell of the
battery pack. This can improve the discharging performance of the
battery! This charger uses the optimised calculation to control the
tolerance in the range of ± 0.01V!
"Fast charging": Select this mode to finish charging process earlier.
Principle: When the current goes down to 1/5 of the current you set
during the CV term, it will stop the process and eliminate the forcible
requirement of the balance precision (whether it has been connected
to the balance port). The charging capacity may be a bit smaller than
normal charging, but the process time will be reduced.
"Storage mode": This is for charging or discharging Lithium batteries
not to be used for the time being. In order to reduce the wastage, you
can select this mode to remain the power to 40% to store. The final
voltage is different from the type of the battery: Lilo 3.75 V, LiPo
3.85 V, LiFe 3.3 V.
This is an intelligent program. lf the voltage of the battery at its
initial stage is over the voltage level to storage, the program will
start to discharge,and if it is lower, the program will start to charge
automatically. In order to ensure each battery meets the demand,
the individual plug of the battery pack should be connected to the
individual port of charger.
"Discharge mode": Theoretically, Lithium batteries do not need to
be discharged, especially deep-discharged. This feature is to ensure
the power wastage of the Lithium battery over 90%, to avoid the
overcharge of the individual battery, you should connect the balance
plug of the battery to the charger, and the current may not exceed
1 C.
7