ANSMANN Racing xMove 2.0 Station Mode D'emploi page 6

And you can set the maximum temperature, which the battery should
reach during charge. Once a battery reaches this value the process
will be terminated to protect the battery. When it is selected as an
USB port, you can connect the charger to your PC with an optional
USB cable.
This can utilize the optional software that can show you the charge
process at PC (see the screen
A4
When a NiMH or NiCd battery is on the cyclic process of charge/
discharge, it can become warm. The program inserts a time delay to
occur after each charge and discharge process to allow the battery
adequate time to cool down before being subjected to the next
process (see the screen ). The value ranges from 1 to 60 minutes.
A5
If you are not sure, you can set it over 10 minutes.
The charger will automatically supply the trickle function to achieve
the full charge without overheating the battery after fast charge has
been teminated. You can alter the trickle value when the charger
shows you the screen .
A6
When you start a charge process, the integral safety timer
automatically starts running at the same time. This is programmed to
prevent overcharging the battery if it proves to be faulty, or if the ter-
mination circuit cannot detect the battery is full.
Types
Standard voltage
(V/cell)
Max. charge voltage cut off level
(V/cell)
Allowable
fast current
Min. discharge voltage cut off
level (V/cell)
6
).
shows you this
A7
LiPo LiIo
3.70 3.60
4.20 4.10
<1C <1C
>3.00 >3.00
program can be on or off, and you can set the maximum safety time,
the value ranges from 10 to 720 min. At the same principle,there is
a maximum cap activity-limited function. See
from 10 to 20000 mAh.
At the screen you can set the audible sounds to be on or off by
A9
this program.
When you use the car battery to supply power for charger, screen
shows you this program monitors the voltage of input DC battery.
lf the voltage drops below the value you set the operation forcibly
terminated to protect the input battery. You can adjust the brightness
of the LCD screen at the charger (see
Please refer to the information chart below, and select
the correct parameters for each battery, to avoid serious
damages of the batteries and charger!
LiFe NiMH
3.30 1.20
3.60 1.60
<4C <2C
>2.00 >1.00
Instruction Manual
, the value ranges
A8
A10
).
A11
NiCd Pb
1.20 2.00
1.60 2.45
<2C <0.4C
>0.85 >1.75