BEGLEC JBSYSTEMS FX 1700 Mode D'emploi page 4

ENGLISH
Used with the supplied timer remote controller:
 Connect the special 5pin connector (1) to the
remote input on the back of the fogger.
 Manual operation: When the fogger is ready for
operation, the green LED on top of the "manual
fogging" button (4) turns on. The fogger produces
fog as long as you press this button. (after some
time the green LED will turn off to indicate that the
fogger is warming up again, during this time you
can't produce any fog)
 Continuous operation: press button (5)  the red
LED will be lit while the fogger produces fog
continuously. Press the button again to stop
continuous fogging.
 Timer operation: press the "timers on/off" button
(6) until the red LED is lit. The fogger produces fog
at regular intervals as set by the two parameters (2)
and (3):
 Duration knob (2): used to set how long the
fogger will produce fog (range = 0,5s ~ 10s)
 Interval knob (3): used to set the time it takes (interval) between 2 bursts of fog (range = 9s ~ 280s)
Used with the optional wireless RC-1 controller:
 Connect the special 5pin connector (1) to the
remote input on the back of the fogger: the red
LED (3) turns on.
 Fix the remote receiver (2) with its magnetic
surface to the back of the fogger.
 When the fogger is ready for operation, the green
LED (4) turns on.
 The fogger produces fog as long as you press one
of the 2 buttons (5) on the wireless remote. (after
some time the green LED on the receiver will turn
off to indicate that the fogger is warming up again,
during this time you can't produce any fog)
Remark: the maximum distance between the
wireless remote and the fogger is about 25m.
MAINTENANCE
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
JB SYSTEMS
®
OPERATION MANUAL
3/25 FX 1700 FOGGER
ENGLISH
Cleaning the fogger:
To prevent obstructions in the heater, pump and tubes, the fogger should be cleaned on a regular basis:
every 100h of continuous operation is a good reference.
 Switch the fogger off
 Remove the nozzle (metal part where the fog leaves the fogger)
 Remove the fog liquid from the tank
 Fill the tank with about 1liter of a solution containing 80% distilled water and 20% white vinegar.
 Switch the fogger on and wait for about 8minutes (warm up time)
 Put the fogger in continuous operation mode until the tank is empty
 Put the nozzle back in place
 Remove the eventual residues of the cleaning solution and refill the tank with fog liquid.
Remark: cleaning should be done outside; an awful smell is produced by the vinegar solution!
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input: AC 230V, 50Hz
Power consumption: 1700 Watt
10A "auto reset" thermal circuit breaker
Fuse:
Output: 21000 cubic ft/min
Warm up time: 8 min
Tank size: 5L
Size: 435 x 280 x 290 mm
Weight: 10 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS
®
OPERATION MANUAL
4/25 FX 1700 FOGGER