Thermo King B-100 10/20 Manuel D'installation page 2

Table des Matières

Publicité

This installation manual was written to help assist with the installation of Thermo King refrigeration units powered by vehicle batteries onto either a truck or a van.
The manual comprises sections on condenser, evaporator and other modules that are mounted on the truck or van body, as well as sections on components and wiring
that are to be connected to the vehicle engine from which the unit derives power. Due to its complexity, do not attempt this installation unless you:
Are an experienced mechanic.
Can safely lift 34 kg (75 lb).
Are certified or approved in the repair and maintenance of transport refrigeration systems.
Have a basic understanding of electricity and electrical wiring.
Have the necessary tools and equipment to complete the installation.
Have a truck body designed and built to meet the requirements of this installation.
This manual is published for informational purposes only. Thermo King makes no representations or warranties, express or implied, with respect to the information,
recommendations and descriptions contained herein. Information provided should not be regarded as all-inclusive or covering all contingencies. If further
information is required, Thermo King Corporation Service Department should be contacted.
Thermo King's warranty shall not apply to any equipment which has been "so installed, maintained, repaired or altered as, in the manufacturer's judgment, to affect
its integrity".
Manufacturer shall have no liability to any person or entity for any personal injury, property damage or any other direct, indirect, special, or consequential
damages whatsoever, arising out of the use of this manual or any information, recommendations or descriptions contained herein.
Introduction
Eng
i

Publicité

Chapitres

Table des Matières
loading

Table des Matières