Installation And Connection - Bartscher 190.160 Mode D'emploi

•
Never touch internal parts of the device.
•
Do not move or tilt the device during operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

ATTENTION!
Installation and maintenance of the device must be performed only by qualified
personnel!
Set-up
•
Unpack the device and dispose of packaging material.
•
Place the device on a flat, secure surface which can support the device's weight
and is not sensitive to temperature.
•
Never place the device on a flammable surface (e.g. table cloth, etc.).
•
Never place the device near a source of open flame, electric heater, or any other
source of heat.
•
After set-up, the machine should be adjusted using the adjustable legs to ensure
even distribution of coffee to each cup.
•
Each electrical plug circuit should be secured to a level of at least 16A. The device
can only be plugged directly into a wall socket – do not use multiple-socket clusters or
power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
Hose and water decalcifier installation:
•
Remove the run-off tray and connect the elastic hose to its proper location. Connect
the other end of the hose to the water decalcifier device. Connect the decalcifier device
to the water supply using the second hose. The water pressure should be at a
maximum of 4 bar.
- 32 -