Installation And Connection; Operating - Bartscher 114.356 Mode D'emploi

•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

•
Clean the electric warming tray with a damp, soft cloth before first use.
Dry it thoroughly afterwards.
•
Connect the device to an appropriate single power socket.
•
Engage the warming tray using the toggle switch which can be found at the backside
of the device.
•
Set the desired temperature (up to 95
lamp flashes up.
•
The red control lamp distinguishes after the set temperature has been reached.
When the warming tray cools down the red control lamp flashes up again and tray
will be heated up. This function prevents the warming tray from overheating.
°
C) using the turning knob. The red control
- 23 -