Installation And Connection; Operating - Bartscher A200.052 Mode D'emploi

•
Protect the device from rainwater, moisture and dampness.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Do not place any acid chemicals, gases or other, easily inflammable materials near
this device.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

•
For hygiene reasons, before first use fill the device with approx. 6 litres of water,
adjust for the highest temperature and boil for approx. 5 minutes. Then drain the
container.
•
After boiling, rinse the container with clean water and drain it again.
•
Clean the glass cover thoroughly with warm water and a mild cleaning agent. Then
rinse the cover with clean water and dry it thoroughly with the use of a soft cloth.
•
Adjust the temperature control in the „0" position.
- 25 -