Installation And Connection - Bartscher 406.051 Mode D'emploi

WARNING! Hazard via electrical current!
The device may cause injuries due to improper installation!
Before installation, the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Remove the protective foil from the appliance. Ensure that it has been completely
removed.
•
Place the device on top of an even and safe surface which supports the weight of
the device.
•
Not at any time should you place the device on an inflammable surface.
•
Do not place the device near the open fire sources, electric ovens, heating stoves or
other heat sources, for example direct sunlight. Exposition to high temperatures may
cause damage to the device surface or may negatively influence cooling power and
energy consumption.
•
Set up the cold cabinet at an ample place, where a proper air circulation is possible.
A minimum distance of 5 cm must be kept to walls and other items.
•
Do not set up the cold cabinet at places with high humidity or high temperatures, as
these effects may damage the device.
•
For the first time use, wait for 2 hours after handling and then plug the wall socket
and start it.
•
Never punch holes into the cold cabinet. Never install foreign matters/ substances
on the cold cabinet .
•
Never put any heavy load on the top of the cold cabinet.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Use
•
Prior to first use, clean the unit (see 6.2 Cleaning).
•
Connect the unit to a single socket.
•
Turn the unit on via the green switch labeled ON/OFF, located under the display; the
switch should be in the "I" position.
- 25 -