Installation And Connection; Operating - Bartscher IMBISS PRO 162.500 Mode D'emploi

WARNING! Risk of injury!
Hot oil splashes and fat explosions respectively may cause burns at hands and face!
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

CAUTION!
The device may be installed by a qualified specialist only.
•
Discard the complete packing material after unpacking the device.
•
Place the device on top of a solid, even, safe and stable surface that tolerates the
weight.
•
Not at any time you should place the device on top of an inflammable surface (such
as: table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Avoid installation spots with close contact to water.

5.3 Operating

•
Wash the unit prior to first use (see 6.2 „Cleaning").
CAUTION!
The deep fat fryer can only be operated by personnel properly trained in its use
and the dangers present during deep fat frying.
•
Carefully install the control panel at the rear edge of the oil reservoir, until the panel
is connected to the oil reservoir handles. In this manner the control panel is properly
mounted. For safety reasons, the unit only functions when the control panel is
properly installed. A microswitch enables the unit to enter stand-by mode.
- 26 -