Vermeiren Eclips+ AD Mode D'emploi page 20

EN
The screws (A) and (B) must then be retightened properly.
To secure the boomerangs properly, notches have been put on the side of the inner
telescope rail (1) that indicate the seat width settings 390 mm, 420 mm, 440 mm, 460 mm,
480 mm and 500 mm. When the boomerangs are pushed together, these notches must fit
exactly to the edge of the outer telescope rail (2). Then secure the disc screws (3) in such a
way that they can be tightened fully. If the disc screws (3) cannot be tightened so they are
flush, it will be because they are not settled in their intended recesses, so they cannot be
secured properly.
If the disc screws are not tightened so they are flush, and if they are not settled in the
recesses in the inner telescope rail, they can get damaged and restrict seat width
adjustments in the future.
3.5 Seat
"
!
WARNING:
the appropriate tool.
"
!
WARNING:
tightened and do not hang through.
C
B
The seat frame is available in one of three seat depths 42 cm, 44 cm, 46 cm (16.54 in.,
17.32 in. and 18.11 in.).
The standard seat depth of the cover is 42 cm (16.54 in.). To close the gap between the
back frame and the seat, fold the flap of the backrest under the seat ( Velcro fastening).
2
1
3
Risk of injury - Make sure that all screws are properly tightened with
Risk of injury ! Ensure that all the securing straps are sufficiently
C
The seat can be used for a seat width of 390
mm to 500 mm. Loosen the Velcro fastening
A
on all 5 straps (A) and pull the straps to the
length you require by pulling them through
the flaps (B).
When you have adjusted the straps to the
required length, fasten them back up. The
cushions can now be added to the seat by
fitting the cushion straps to the side-straps on
the adjustable seat.
!"#$%&-%
Eclips+ AD
2011-03
2
3