Adjust The Brakes; Adjusting Of The Footrests - Vermeiren Eclips+ AD Mode D'emploi

EN
3.7

Adjust the brakes

"
!
WARNING:
dealer.
Adjust the brakes according following rules:
3.8

Adjusting of the footrests

3.8.1 Length of the footrests
"
!
CAUTION:
ground. Keep a minimum distance from 60 mm (2.36 in.) above the ground.
Adjust the length of the footrests as follow (in three different positions):
1. Remove the screw
2. Adjust the length of the footrest to a comfortable length.
3. Tighten the screw
3.8.2 Depth of the footplate
Adjust the depth of the footplate as follow (in three different positions):
1. Remove the screws !.
2. Adjust the depth of the footrest to a comfortable position
Position 1: hole 2 and 4
Position 2: hole 3 and 5
Position 3: hole 4 and 6
Tighten the screws properly !.
3.
Risk of injury ! Brakes may only be adjusted by your specialist
3
2
Risk of damage ! Avoid that the footrests make any contact with the
!
.
!#
properly.
(Fig B)
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever
backwards.
"
3. Loosen the bolts
mechanism can slide over the guide
4. Pull the brake mechanism over the guide
the desired position.
5. Retighten the bolts ".
6. Check working of the brakes.
7. If necessary repeat the above steps until the
brakes are adjusted well.
(Fig B)
!"#$%'/%
Eclips+ AD
2011-03
!
so the brake
$
.
$
(Fig A)
.
(Fig A)
to