Mettler Toledo IND780 Guide D'installation page 31

IND780 Terminal Division 2 and Zone 2/22 Installation Manual
Harsh Enclosure
The harsh enclosure is made of stainless steel and designed to rest on a flat
surface such as a table or desk top, or to be mounted to a vertical surface with
optional mounting brackets. In desktop configuration, the front panel angle is
approximately 70 degrees from vertical. In wall mount configuration, the front
panel is approximately 40 degrees from vertical, and reversible (angled up or
down).
Desktop Mounting
If the IND780 terminal is to be placed on a flat surface, the four rubber feet
included with the terminal should be adhered to the bottom of the enclosure to
prevent sliding. Peel each foot from the protective paper and press it onto one
corner of the bottom of the enclosure, as shown in Figure 2-6.
Preparation for Wall Mounting
An optional wall bracket kit is available for wall mounting the IND780 harsh
enclosure to a vertical surface. To prepare the enclosure for wall mounting, follow
these steps:
1. Establish orientation of enclosure (above or below eye level)
2. Install enclosure on brackets
3. Mark attachment points
4. Install mounting hardware
5. Mount terminal hardware
Setting Front Panel Orientation
Establish whether the terminal will be mounted above or below eye level. If it will
be mounted at or below eye level, the orientation of the front panel must be
reversed. Follow these steps:
1. Open the enclosure.
2-16
Figure 2-6: Rubber Feet for Desktop Mounting