Psio1 Auxiliary Device Control - Description - CAME PS4000-HW Manuel D'installation

PSIO1 Auxiliary device control - description

10
2
1*
1- Terminals for powering te 230 V a.c. board
2 - Power surge protection fuse
3 - PSIO1 Board protection fuse
4 - Terminals for connecting to RBMP1 or to another PSIO1
5 - Terminals for connecting up input devices (Coils,
Photocells, etc.)
The minimum, double insulated, cable section, depends on the characteristics and dimensions of the system, and must
not be less than 2.5 mm². Before connecting up the device, cut off the mains power supply.
Have in place a suitable dual pole cut-off switch with minimum contact openings of 3 mm, and section the power
PS TOKEN - Hardware and wiring
3 4 9
8
6 - DIP Switch
7 - "Relay ON" warning LED light
8 - Terminals for connecting up control devices
(i.e. traffi c lights, magnetic coils, etc.)
9 - "Communication ON" warning LED light
10 - "Board power ON" warning LED light
supply;
5 6
7
15