Replacing The Bobbin Holder; Replacing The Light Bulb - ELNA eXplore 320 Mode D'emploi

Replacing the Bobbin Holder

Insert the bobbin holder into the hook race.
1
Make sure the knob of the bobbin holder fits next to
2
the stopper on the race.
1
Knob
2
Stopper
Replace the bobbin.
3
Attach the needle plate, inserting the two guide pins
into the holes in the needle plate. Tighten the screw
firmly with the screwdriver.
3
Guide holes
4
Screw
Clean the machin with a soft cloth. Do not use chemical
solvent.
Store the machine in cool and dry place.
Do not store the machine in an area of high humidity,
near a radiator or in direct sunlight.

Replacing the Light Bulb

WARNING:
When replacing the bulb, switch off and unplug the
machine.
Wait for the light bulb to cool down before touching it.
Remove the cap and screw. Remove the face plate.
1
Cap
2
Screw
3
Face plate
Push and turn the bulb counterclockwise to remove it.
Push and turn the bulb clockwise to replace it.
4
Light bulb
90