Service And Warranty - AVG LOUISIANA AVL-306CS2 Instructions D'installation Et Guide De L'usager

MAINTENANCE
SAFETY WARNING: NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN
CLEANING THE EXTERIOR SURFACES
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent or
steel wool pads, which will scratch and damage the stainless steel surface. For heavier soil, use a liquid
degreasing cleaner. Use a stainless steel cleaner to clean the surface of the hood. Avoid getting cleaning solution
onto or into the control panel. Follow directions of the stainless steel cleaner.
CAUTION:
USE SOFT TOWEL TO WIPE OFF THE CLEANING SOLUTION, GENTLY RUB OFF ANY STUBBORN SPOTS.
USE DRY SOFT TOWEL TO DRY THE HOOD. ALWAYS SCRUB LIGHTLY WITH CLEAN COTTON CLOTH AND IN THE
DIRECTION OF THE GRAIN.
DO NOT ALLOW DEPOSITS TO ACCUMULATE OR REMAIN ON THE HOOD. DO NOT USE ORDINARY STEEL WOOL OR
STEEL BRUSHES. SMALL BITS OF STEEL MAY ADHERE TO THE SURFACE AND CAUSE RUSTING.
DO NOT ALLOW SALT SOLUTIONS, DISINFECTANTS, BLEACHES OR CLEANING COMPOUNDS TO REMAIN IN CONTACT
WITH STAINLESS STEEL FOR EXTENDED PERIODS. MANY OF THESE COMPOUNDS CONTAIN CHEMICALS, WHICH MAY
BE HARMFUL. RINSE WITH WATER AND WIPE DRY WITH A CLEAN CLOTH.
CLEANING THE GREASE FILTER
This unit is equipped with two sets of filters: baffle and reinforced micro mesh aluminum filters. The filters are
intended to filter out residue and grease from cooking and are required to be kept clean. Filters should be
cleaned after every 30 hours of use. Remove and clean by hand in soapy water or in the dishwasher. Dry filters
and re‐install. If cleaning the filters in the dishwasher, use a non‐phosphate detergent. The use of detergent with
phosphate may cause discoloration of the filters, but will not affect their performance. This discoloration is not
covered by the warranty.
REPLACING THE FILTERS
If filters wear out due to prolonged use, please contact your service/parts provider for replacement filters.
NOTE:
ALSO REPLACE DAMAGED FILTER THAT HAS PUNCTURED OR BROKEN MESH, BENT OR BROKEN FRAME.
REPLACING THE LED LIGHT BULBS
CAUTION: LED lamps can only be replaced with a new LED lamp. The lamp rating must be equal to the one already
used. Make sure all the control switches are off and the hood is unplugged. Please f ollow these instructions:
1. Take out the filters and remove the wire connection of the lamp.
2. Press the spring in the direction of the arrow then you can take out the lamp.
3. Screw in new lamp in reverse direction. Connect the wire of the lamp.
4. Replace the filters.
SERVICE AND WARRANTY
We warrant our hood against defects in materials and workmanship under ordinary residential use for one
year from the date of original retail purchase. This limited warranty applies to any repair and /or
replacement parts.
This limited warranty is not subject to improper installation, accident, misuse, neglect, fire or other external
causes, alterations, repair or commercial use.
Contact our Service Department from: Monday through Friday, 8h30 to 16h30 (Eastern STD Time)
AGI SERVICE
Tel: 450.963.1303 Toll free: 1.888.651.2534
Fax: 450.963.1416
Web/E‐mail: www.agiservice.ca / customer agintl.qc.ca
@
21