Electrical Installation - AVG LOUISIANA AVL-306CS2 Instructions D'installation Et Guide De L'usager

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 
INSTALLING THE HOOD MOUNTING BRACKET
 
The minimum hood distance above cooktop must not be less 
than 28" for an electric cooking surface and no less than 30" 
for a gas cooking surface.
Distances over 30" are at the installer's and users' discretion, 
providing that ceiling height permits. 
 
**installation over 30'' may reduce efficiency 
 
ELECTRICAL INSTALLATION 
WARNING 
THIS  RANGE  HOOD  MUST  BE  PROPERLY  GROUNDED.  TURN  OFF  ELECTRICAL  POWER  AT  SERVICE 
ENTRANCE BEFORE WIRING. CHECK TO MAKE SURE THAT THE ELECTRIC CHORD IS NOT IN CONTACT WITH 
THEE SHARP EDGES OF THE APPLIANCE. 
 
IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED ELECTRICIAN 
IF THE GROUNDING INSTRUCTIONS ARE NOT COMPLETELY UNDERSTOOD OR IF THERE IS DOUBT AS TO 
WHETHER THE APPLIANCE IS PROPERLY GROUNDED. DO NOT USE AN EXTENSION CORD. IF THE POWER 
SUPPLY CORD IS TOO SHORT, HAVE A QUALIFIED ELECTRICIAN INSTALL AN OUTLET NEAR THE APPLIANCE. 
   This appliance must be plugged into an outlet that is properly installed and grounded.  In the event of 
an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for 
the electric current. This appliance is equipped with a cord having a grounding wire with a grounding 
plug.
   Set the electrical power supply within the space covered by the decorative chimney.
   Position the outlet offset so that the power cord will not interfere with the round duct.
   Make  sure  this  does  not  interfere  with  a  mounting  bracket  fastening  area  or  with  the  decorative 
chimney (where the chimney touches the wall)
 
 
17

Publicité

Table des Matières
loading

Table des Matières