Selecting The Transmission Speed (Rs-232C); The Power Is In Standby Mode; Fan Mode Setting; Returning To The Default Settings - Sharp XV-Z3000U Mode D'emploi

Using the "Options" Menu (Continued)
2 Selecting the Transmission
2 2
2 2
Speed (RS-232C)
Make sure that both the projector and computer
are set for the same baud rate.
Selectable
items
9600bps Transmission speed is slow.
115200bps Transmission speed is rapid.
3 Reducing the Power
3 3
3 3
Consumption When the
Power Is in Standby Mode
When "STANDBY Mode" has been set to "Stan-
dard", the RS-232C function is activated and
power is consumed even in standby mode. It is
recommended that "STANDBY Mode" be set to
"Eco" when it is not being used. This reduces
power consumption when the projector is in
standby mode.
Selectable items
Standard The RS-232C function is
activated even if the projector is
in standby mode.
Eco The RS-232C function is
switched off when the projector
is in standby mode.
Note
• When you want to control the projector using
the RS-232C function, set to "Standard".
50
Description
P
R
Description
Menu operation n Page 41

4 Fan Mode Setting

4 4
4 4
This function changes the fan rotation speed.
Selectable
items
Normal Suitable for normal environments.
High Select this when using the projector at
altitudes of approximately 4,900 feet
(1,500 meters) or more.
When "Fan Mode" is set to "High", the fan rotation
speeds up, and the fan noise becomes louder.
5 Returning to the Default
5 5
5 5
Settings
Use "All Reset" to initialize all the adjustments
you have made to the default settings.
Note
The following items cannot be initialized.
• "Fine Sync" menu
– Special Modes
• "Options1" menu
– Lamp Timer (Life)
– Language
6 Selecting the On-screen
6 6 6 6

Display Language

The projector can switch the on-screen display
language among 11 languages.
English Svenska
Deutsch Português
Español
Nederlands
Français
Italiano
Description