sylvac D70A Manuel D'utilisation page 62

7.4. Display mode without tolerance
This display mode is very adapted to be used with incremental probes like Heidenhain. (MT-101)
This mode allows to display only the numerical value, without tolerance indication.
It is also possible to change the preset value (calibration) directly from this screen. Press on the
value as shown on the below picture, an input the new value with the keyboard.
If the double display mode is se-
lected, the 2 characteristics can
move together, but
only 1 is active.
The lateral buttons have an effect
only on the active characteristic.
For selecting the active charac-
teristic, press on it and the top of
the box will become
green.
62
The lateral button have an
effect only on the active
characteristic