sylvac D70A Manuel D'utilisation page 44

Soft polyurethane tubes 6*4mm : The D70A are
fitted with 2 connectors for air tube with 6mm
external diameter and 4mm internal diameter.
We advice to use soft polyurethane tubes from
SMC, because their flexibility prevent the display
to knock over due to the pressure of the tubes on
the table.
Soft polyurethane tubes 8*5mm : The air prepa-
ration unit delivered by Sylvac is fitted with a
connexion for 8mm tubes (external diameter)
This footswitch with a robust construction can be
926.7021 configured in different ways : preset, measurement
transmission, start dynamic measurement etc...
804.2202 Accessory for panel mounting.
This M-Bus module is fitted with 8 input/out-
804.2130 puts isolated with optocouplers allowing to get
additional functionalities.
M-Bus cable for D70A. This cable allows to connect the
804.2205
compatible M-Bus modules on a D70A display unit.
RS232 cable. This cable allows to connect a
804.2201
D70A display to a computer or a PLC.
804.2204 Cross-cable RS232 1X1 to communicate with PC
2.3.4. Connectors
2 inputs for AIR at 2BAR
(0.2Mpa) (air filtered at 5μm
and regulated at 0.1BAR /
0.01MPA). NEVER INCREASE
4BAR/0.4MPA. It is very rec-
ommended to use the FRL (Air
preparation set ref 804.2203.)
See details chap. 2.3.5
Output to the Air gage
To connect m-bus modules
(Optional)
24 VDC power supply. If you choose this connector to power the
display, the ON-OFF switch will be deactivated.
44
RS232 connector for connec-
tion to a PC
Multi-function footswitch
connector
Mini-USB connector for pow-
er supply and measurement
transfer to a PC
On/Off switch
(press 2s. for
shutting down)