sylvac D70A Manuel D'utilisation page 55

6.1.2. Part 2
This screen allows to input tolerances and the characteristics (nominal and master)
Just press on the corresponding edit box to input the needed values.
6.1.3. Part 3
This screen allows to setup a part sort according to their dimension. Up to16 classes can be define.
6.1.3. Part 4
This screen allow to display or not the control limits (warnings) and to define them. Control limits
are warning that inform the user is the measure become to close to the tolerances limits. (yellow
color on the bargraph)
Define the control limits
This part is hidden if « no » has been selected
Example of characteristic displayed with control limits
55
E
Part ok
Part ok with warning
Part not ok