sylvac D70A Manuel D'utilisation page 46

3
TX
4 IN1
5
Gnd
6
7
IN2
8 & 9
2.3.7 . Le connecteur M-Bus
2.3.7 . Mini-USB
The mini-USB connector has 2 functions:
1. Power supply through a wall mounted transformer. This transformer supplies a regulated
5V/1A DC voltage.
2. Measurement transmission. If you connect your D70A to a PC, the PC will detect and
install automatically the D70A as a standard USB keyboard with the standard drivers of your
operaing system (Windows, Mac OS etc..). When you will send the measurement, the
value will be written on your PC screen where your cursor is, in the same way as it would
have been typed with a keyboard.
Message from Windows telling you that the D70A is well detected and installed :
2.3.8. The 24VDC connector
It is advised to use this power supply when the D70A is panel mounted. Using this power supply
instead of the mini-USB will deactivate the ON-OFF switch. Therefore, when the D70A is pow-
ered, it will start automatically.
2.3.9. The USB stick connector
It is possible to save measurements on a CSV file. In this case the display must be set the follow-
ing way : Configuration ->Transfer -->USB key
Then once the user either press on the « PRINT » button of the measuring screen or on the foots-
wich, one line will be added on the CSV file. (a « Sylvac.csv » file is created when the operator
transfers the data for the first time). When the USB stick has been correctly detected, a USB logo
will appear on top bar. If the USB stick is not connected when the operator transfers the measure-
ment, an error message will pop up.
Output Transfer of data
Input Do not use. Only for testing.
- Ground
Not used
Input Do not use. Only for testing.
Not used
46