sylvac D70A Manuel D'utilisation page 53

6.1. Définition
After pressing the icon «
It gives the possibility to define the tolerances, the master, the master part characteristic,
the resolution of each of the 2 available measurement configurations.
This window is divided in 2 parts for the configuration of the 2 measurement configurations :
6.1.1. Part 1
Formula choice :C(1) / C(2) / C(1) + C(2) / C(1) - C(2) / -C(1) / -C(2) / -C(1) + C(2) --> C = probe
it is possible to affect a coefficient for each probe or air gage on «
definition », the windows below appears.
Choice the part 1 or 2
Setup »
53
E
Go to the
screen 1, 2 ,3
or 4
Static = direct
reading or
dynamic :
Max, Min,
Max-
Min, Average
or Median
For measur-
ing internal
or external
diameters. It
defines the
indicators co-
lour, and gives
information
to the user if
the partcan be
used again.