General Instructions; Batteries; Function Description - Truma Mover XT L Instructions De Montage

– Sensitive objects such as cameras, DVD players etc. must
not be kept in the stowage box near the control unit or the
motor cables, as the powerful electromagnetic fields may
damage them.
– The empty weight of the vehicle is increased by the weight
of the Mover XT L, thus reducing the vehicle's payload.
– Remove the plug / adapter from the safety socket after ma-
noeuvring, otherwise the battery will be discharged.
Quiescent current with plug / adapter inserted < 80 mA.
Quiescent current with plug / adapter unplugged < 150 µA.
– Inspect the system for damage before use.
The system must not be used if it is damaged.

General instructions

The Mover XT L has been designed to cope with inclines of up
to approx. 25 % bearing a gross weight of 1200 kg or 20 %
bearing a gross weight of 1500 kg on a suitable surface.
Depending on the weight of the caravan, the Mover XT L may
not be able to overcome obstacles more than about 3 cm in
height without auxiliary equipment (please use ascent chocks).
As a result of the characteristic properties of a radio signal, it
may be interrupted by terrain / objects. This reduces reception
quality in small areas around the caravan, as a result of which
the operation of the Mover XT L may be briefly interrupted.
When the Mover XT L is switched off using the remote
control, the control unit remains in standby. In order to
switch off completely the battery must be disconnected or an
isolating switch installed.

Batteries

Recommended battery capacities
Button cell technology
Gel / AGM
Lead-acid battery (liquid electrolyte)
Starter batteries are not suitable
Batteries with greater capacity allow the equipment to
be used for longer.
Charger
For optimum battery charging we recommend the Truma
BC 10 charger, which is suitable for all battery types up to
200 Ah.
Notes for handling batteries
– When handling batteries, pay attention to the manufac-
turer's safety instructions and data sheets
– Ensure that the terminal clamps are secure.
– Secure battery poles with protection caps in order to pre-
vent a short circuit
– When removing the battery, first disconnect the earth con-
nection (negative terminal), followed by the positive termi-
nal. When installing the battery, first connect the positive
terminal followed by the negative terminal.
14 EN
Battery care (including maintenance-free
batteries)
In order to achieve a long battery service life, attention must
be paid to the following points:
– Batteries should be fully charged before and after removing
power,
– for stationary periods of longer than 24 hours, interrupt
power circuit (e.g. using circuit breaker or by disconnecting
the battery poles),
– for longer stop periods the battery must be disconnected
and charged for 24 hours at least every 12 weeks.
In winter, store fully charged battery in a cool and
frost-free place and recharge at regular intervals (every
12 weeks).

Function description

Always observe the operating instructions and the
"Safety instructions" prior to starting! The vehicle owner
is responsible for correct operation of the device.
Please note that the Mover XT L is only suitable for
single-axle trailers.
The Mover XT L is a manoeuvring system which allows a cara-
van to be manoeuvred without the aid of the towing vehicle.
It consists of two separate drive assemblies, each with its
own 12 V DC motor. These units are mounted on the frame
of the vehicle in the immediate vicinity of the wheels, and are
connected by a lateral bar.
Once the drive rollers have been engaged using the remote
control, the Mover XT L is ready for operation. It is operated
exclusively via the remote control, which transmits radio sig-
nals to the control unit. A separately installed 12 V lead-acid
battery or suitable lead-gel battery (not supplied) provides the
control unit with electrical power.
at least 38 Ah
at least 48 Ah
at least 75 Ah