Publicité
16
Instructions for Use
Use
Switching on and Use of the TV81 Navigator
To switch on the TV81 Navigator, it is sufficient to provide the mains
supply. The controller automatically recognizes the presence of the
interlock and start signals and starts the pump.
"Soft Start" mode is provided in order to switch on the pump after a
long period of standstill. To start the pump with "Soft Start" mode
active, this must be enabled via software.
For the "Soft Start" mode activation procedure, see the "Signal
Description" paragraph in the "Technical Information" chapter. The
flashing rate of the green LED on the TV81 Navigator front panel
indicates system operating conditions:
Switching off the TV81 Navigator
To switch off the TV81 Navigator, it is sufficient to remove the mains
supply. The integrated controller immediately stops the pump.
Emergency Stop
To stop the TV81 Navigator immediately in an emergency condition,
remove the power cord.
138/192
on steadily: the pump is rotating normally;
slow flashing (period of about 400 ms): the system is in ramp, or
in Stop, or in "Waiting for interlock" status;
fast flashing (period of about 200 ms): error condition.
Turbo-V 81-AG Navigator Controller User Manual / 87-901-004-01 (G)
Publicité
Chapitres
