Operation; Switching On/Off The Pump - Agilent Technologies Turbo-V 70 PCB 24 Vdc Notice De Mode D'emploi

17 Technical Information

Operation

Operation
Make all vacuum manifold and electrical connections and refer to
Turbo-V pump instruction manual prior to operating the Turbo-V
controller.
WARNING! To avoid injury to personnel and damage to the equipment, if the pump is
laying on a table make sure it is steady. Never operate the Turbo-V pump
unless the pump inlet is connected to the system or blanked off.
The controller operates completely automatically after the remote
start command is given.

Switching On/Off the Pump

To switch on the pump is necessary to remove the connection
between pin 12 of J4 connector and pin 15 (ground) of the same
connector. To switch off the pump is necessary to connect pin 12 of
J4 connector to pin I5 (ground) of the same connector.
198/208
WIN = Window
R = Read
W = Write
T = Type
L = Logical
N = Numeric
A = Alphanumeric
Turbo-V 70 PCB 24 Vdc Controller User Manual / 87-900-933-01 (H)