A.battery Removal; B.footplate Angle Adjustment; Integral Joystick - Sunrise Medical Guardian Microlite Garnet Mode D'emploi Et Garantie

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

I X . S e t - U p , A d j u s t m e n t & U s e
A. BATTERY CASE REMOVAL
To remove the batteries for transporting or servicing:
1. Remove Battery Case
a. Pull red battery pack release (A) forward.
d. To remove battery pack, lift up on battery pack handle (B).
2. Battery Installation
See Section XI. Batteries, D for installation and wiring diagram.
Batteries may weigh up to 55 lbs. Care must be taken to avoid injury when lifting
up on battery straps.
B. FOOTPLATE ANGLE ADJUSTMENT (Ruby/Ruby 11 only) (Figure 3)
Adjust bolt (C) until desired angle is reached.
Avoid opening doors with footplate or legrests. Damage or injury may result.
C. INTEGRAL JOYSTICK (Ruby/Ruby 11 only)
(Figure 4)
1. To Connect
a. Line up receptacle on large rectangular connector (Beau Connector) located behind
the seat with the pins on the connecter located on the joystick harness.
b. Push in firmly.
2. To Disconnect
Pull up on beau connector until it disconnects from the frame mounted receptacle, located
behind the seat.
D. ARMRESTS WIDTH ADJUSTMENT
a. Insert armrest support inside of 1" square tube (D) located on back of the seat.
b. Repeat for other side of seat.
c. Position armrest at appropriate width.
d. Tighten knob screws (E) on square tube.
Avoid pinching fingers in the flip-back armrest.
(Figures 1 & 2)
(Figure 5)
E n g l i s h
1
A
B
2
3
C
4
5
D
E
21
930705 Rev. B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Guardian microlite rubyGuardian microlite ruby 11

Table des Matières