Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of injury or property damage, READ AND UNDER-
STAND the following warnings.
1. Do not fill gas or store near open flame, heater, furnace or combusti-
ble materials.
2. Use only non-aromatic butane gas as recommended by the manufac-
turer.
3. Be sure to put switch down after use.
4. Use only in open air place or well ventilated place.
GB
5. Avoid dropping or causing a hard shock.
6. Do not use iron holder designed for the electrical iron. This may cause
burning of tool body.
7. Do not store under direct sunlight or anywhere that will exceed 40°C
or 140°F. This will cause fire / explosion as gas pressure become
high.
8. Do not store near windshield, in trunk of car.
9. Keep out of reach of infants.
10. Keep hands and combustibles clear out of exhaust opening and tip
housing to avoid burns or fire.
11. Do not immerse in water.
12. Do not try to disassemble or misuse or alter or tamper.
13. Do not wipe soldering iron with alcohol-based cleaner.
14. Cool down before putting protective cap on.
TECHNICAL DATA
D
Gas OPEN / CLOSE
main lever
F
Tip housing
Hot air exhaust
hole
CAUTION: Keep
B
clear as hot air
Ignition button
comes out here
C
E
Window
Knurled nut
G
Soldering tip (or hot
blow nozzle)
Specifications
Length incl. soldering tip:
265 mm / 10 7/16"
Weight incl. gas filling:
126 g / 4.4 oz.
Temperature values:
Soldering iron 250° - 500°C / 482° - 932°F
Hot blow 650°C / 1202°F
Burning time per gas filling:
4 hours with gas control lever set at 2.
Filling quantity:
28 cc / 1.71 cu. inch
Handle contai-
ning butane gas
A
Control lever position for
adjusting gas flow and
also tip temperature
Gas level window
Gas refill-nozzle
14
Publicité
Table des Matières
